At LACT we think SAFETY. These respirators are approved by the National Institute for Occupational Safety and Health (NIOSH) for respiratory protection against hazardous gases, vapors and/or particulates, depending on the air purifying cartridges and/or filters used and the contaminant concentration and/or toxicity; but only if there is sufficient oxygen present in the contaminated atmosphere to support life. Not to be used for sand-blasting. As with any air-purifying respirator, when properly selected and fitted, will significantly reduce, but will not completely eliminate the breathing contaminant(s).
Mask comes with fitting directions and product information. Air Purifying Cartridges as well as extra Filters and caps are sold separately.
Recommended for all solvent-based and water-based contact adhesives, paints, varnishes, epoxies, and polyurethanes. natural white China bristles hold and deliver more liquid to the surface, and they are completely resistant to all solvents. Plain sanded wooden handle provides a comfortable grip and is also solvent resistant. Inexpensive enough to be disposable.
Handiest roller of all The 3" rubber roller is soft enough to avoid marring but firm enough to smooth out all covering materials, and is conductive enough to prevent static build up. Up to 50lbs per square inch can be applied to assure thorough bonding of the adhesive layer. Since there are no axle protrusions on the open end, you can roll close to uprights without danger of marring.
Three 2 1/4" resilient rollers let you cover a lot of territory in a hurry, be it decorative laminate, vinyl, or other adhesive-applied coverings. A favorite for decorative laminates, carpet, floor tile, and other resilient coverings. With the preferred loop handle grip at the roller section, heavy pressure can be applied right where it is needed- at the rollers. The twist-lock handle quickly adjusts from 18" to 27".
Keep one at hand when filling. These are recommended for cleaning PLASTI-CUT files to preserve tooth sharpness. For files that are clogged with adhesive, soak in glue cleanup solvent then use wire brush. this wire brush is suitable for a variety of other purposes, including the removal of pitch from saw blades.